When many metal circular saws are used, the phenomenon of tooth bouncing or rapid wear and tear of the circular saw blades is a headache for enterprises, as the consumption of circular saw blades is also a significant expense for enterprises. So what are the ways to reduce this consumption? Let's analyze the 7 reasons for the damage of the circular saw blade:
1. Saw blade installation incorrect
When installing the saw blade of the circular saw machine, it must also be correctly installed and checked several times. Incorrect installation not only causes the metal circular saw blade to break, but also affects the service life of the circular saw machine.
2. The ammeter setting is incorrect
Incorrect setting of the ammeter can cause damage to the saw blade and the machine.
3. The cleaning work of the circular saw machine is not in place
Especially the iron filings inside, even if they are not cleaned up in time, it will increase the rate of circular saw blade damage and consumption too quickly.
4. The metal circular saw blade must be handled with care
To avoid accidentally falling onto the ground and creating bumps, the surface of the circular saw blade may not be smooth enough, resulting in increased friction.
5. Cutting speed too fast
The cutting speed is related to the material being cut. For different materials, the cutting speed should be adjusted according to the requirements in a timely manner. Many enterprises blindly adjust the cutting speed in order to cut faster, resulting in damage to the metal circular saw blade, which is also the fundamental reason for the damage to the saw blade.
6. The cut material is quite dirty
This kind of situation is relatively rare. Some companies cut materials that are dirty and do not take it seriously. They often send the materials directly to the machine for cutting and never clean the materials to be cut first. This is a wrong mindset because there is a lot of dust, iron filings, and even soil on the materials, which can cause great friction when cutting the metal circular saw blade. Of course, the friction of the saw blade of the large circular saw machine is too fast;
7. The circular saw machine works for too long at once
Usually, it is because companies work more than 12 hours a day, or even 24 hours a day, in order to accelerate production. In this case, the load on the circular saw blade during cutting increases, and the circular saw blade cannot be buffered, leading to rapid wear and tear.
